The use of LCD module

1. Gasket installation: it is best to install the module on the gasket of about 0.1mm on the front panel. The panel should be absolutely smooth to ensure no deformation after assembly and improve the seismic performance.

2. Protective film: the module installed in the finished product has a protective film on the surface of the LCD output device. If there are stains on the surface, it should not be removed before the end of assembly to avoid stains or stains on the output surface.

3. Prevent static electricity: the module is the CMOS circuit with low voltage and low power consumption in the control and drive circuit, which is prone to electrostatic breakdown, sometimes as high as dozens or hundreds of volts of high voltage static electricity. Therefore, it is necessary to be careful to prevent static electricity during operation and assembly.